.467 302 Ford OMC PCM Mercruiser Reversed rotation Marine Distributor Gear


Not always in stock. Fits .467 shaft distributors like most stock 260,289 and 302 Ford marinized engines, MSD, Pertronix and others.

  • INFO
  • Fits the .467 shafts that stock, MSD, Pertronix, Mallory and most distributors use, but these cast iron gears (not cheap bronze!) are not available from them or most anywhere else. Fits most Correct Craft  and other ski boats with right hand rotating Ford marinized engines plus twin-engine boats usually for the right hand (starboard) engine with 302 Ford distributors. Comes un-drilled on purpose so that you don't try to use the original hole and end up too high or low on the shaft, and is shipped with an instruction sheet showing the correct placement. Duplicates factory Rockwell "C" scale hardness to be compatible with stock cast iron camshafts. We've sold hundreds of the reverse gears to fit the stock Prestolite .531 and.500 shafts and this is the same gear except machined for the .467 302 shafts. 

    NOTE: If you have the stock Prestolite marine distributor with the .531" shaft, we sometimes have those too, available elsewhere on this site, or email to info@aaamarine.com

    NOTE: Please check your shaft diameter before ordering. No returns.

    NOTE: We sometimes have complete HEI reverse rotation distributors too.